Keysight N5183B MXG - Settings Conflict Errors (-221) - RCCCH, RDCCH, REACH, and Real-time Applications; RCCCH, RDCCH, REACH, and Real-time Application Conflicts

86 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
-221 Settings conflict; RCCCH is only defined for Radio Configuration 3 and
4. You must set one of these Radio Configurations before configuring
or using this code channel.
An attempt was made to setup the R-CCCH while in a radio
configuration that does not support this channel. This channel is
only available in RC3 and RC4. If the R-CCCH is the desired
channel, you must change to the proper radio configuration before
continuing.
-221 Settings conflict; RDCCH is only defined for Radio Configuration 3 and
4. You must set one of these Radio Configurations before configuring
or using this code channel.
An attempt was made to setup the R-DCCH while in a radio
configuration that does not support this channel. This channel is
only available in RC3 and RC4. If the R-DCCH is the desired
channel, you must change to the proper radio configuration before
continuing.
-221 Settings conflict; REACH is only defined for Radio Configuration 3 and
4. You must set one of these Radio Configurations before configuring
or using this code channel.
An attempt was made to setup the R-EACH while in a radio
configuration that does not support this channel. This channel is
only available in RC3 and RC4. If the R-EACH is the desired
channel, you must change to the proper radio configuration before
continuing.
-221 Settings conflict; Real-time application {name} does not support