Keysight N9041B - Additional Gap to RSF (RIF only); STS Packet Configuration; Segment Length

3 Short-Range Comms & IoT Mode
3.4 HRP UWB Demodulation Measurement
Preset
N0
State Saved Saved in instrument state
Range
0|1|2|4|8
Additional Gap to RSF (RIF only)
Enables an extra 1 ms gap between RSFs and RIFs.
Remote Command
[:SENSe]:HUWB:RIF:AGAP[:STATe] OFF | ON | 0 | 1
[:SENSe]:HUWB:RIF:AGAP[:STATe]?
Example
:HUWB:RIF:AGAP ON
:HUWB:RIF:AGAP?
Preset
OFF
State Saved Yes
Range
OFF|ON
STS Packet Configuration
See "STS Packet Configuration" on page 502
Segment Length
Sets the length of each STS segment (specified in units of 512 chip blocks).
Remote
Command
[:SENSe]:HUWB:STS:SEGMent:LENGth L16 | L32 | L64 | L128 | L256
[:SENSe]:HUWB:STS:SEGMent:LENGth?
Example
:HUWB:STS:SEGM:LENG L64
Couplings See "PHY Mode" on page 501
–
For ERDEV-BPRF, Segment Length is fixed at 64
–
For ERDEV-HPRF, Segment Length is selectable
Available when PHY Mode is not Non-ERDEV and "STS Packet Configuration" on page 502 is not No
STS
Preset
L64
State Saved Saved in instrument state
Range
16|32|64|128|256
508 Short Range Comms & IoT Mode User's &Programmer's Reference