Keysight PXA Series User Manual

Installation Note N9030-90058 17
Option EXM, External Mixing Upgrade Kit
Figure 9 Connecting W29 to Ext Mixer Connector
Figure 10 Proper Orientation of W29
7. If the new front panel SMA connector is not already labeled “EXT MIXER”, locate the External
Mixing Label in the kit.
8. Clean the area around the SMA connector to ensure the new label will adhere well.
9. Peel off the backing from the label and carefully apply the label to the front panel, making sure that
the straight edges of the label are parallel to the top and side edges of the front frame.

Keysight PXA Series Specifications

General

Frequency Range	3 Hz to 50 GHz (depending on model)
Phase Noise	-136 dBc/Hz at 1 GHz and 10 kHz offset (typical)
Resolution Bandwidth	1 Hz to 10 MHz
Input Impedance	50 Ohm
Dimensions	177 mm (H) x 426 mm (W) x 470 mm (D)