15
Conducted Emissions Measurement Examples
Making Conducted Emission Measurements
Adding signals to the signal list
Step Action Notes
1 Clear any existing signal
list
a. Press Meas Setup, Signal List,
Delete Signals, Delete All.
2 Switch to search a. Press Meas Setup, Scan.
Sequence, Search Only.
3 Set the search criteria to
peak criteria and limits
a. Press Meas Setup, More 1 of 2,
Limits, Search Criteria, Peak.
Criteria and Limits.
This is the default setting.
4 Add signals to the Signal
List
a. Press Sweep/Control, Start or
press the Restart key.
Step Action Notes
To Next Page
Loading...
Need help?
General
