Need help?Do you have a question about the Keysight E5052B and is the answer not in the manual?
General| Brand | Keysight |
|---|---|
| Model | E5052B |
| Category | Measuring Instruments |
| Language | English |
Detailed descriptions of each performance test.
Checks the VSWR of the E5052B's RF IN port using a network analyzer.
Checks the frequency measurement accuracy of the E5052B.
Checks the RF power measurement accuracy of the E5052B.
Checks the phase noise accuracy of the E5052B using mixed signals.
Checks the SSB phase noise sensitivity of the E5052B.
Checks the relative level accuracy for the dspectum monitor of the E5052B.
Checks the accuracy of the DC Power output voltage.
Checks the accuracy of the DC Power current measurement function.
Safety precautions for operators and service personnel during adjustment.
Identifies adjustments needed after replacing specific assemblies.
Procedure to isolate failures when the E5052B displays nothing.
Troubleshooting steps for when the E5052B stops during boot.
Utilizes service functions to diagnose analog measurement and power supply issues.
Troubleshooting procedures for E5052B failing performance tests.
Troubleshooting based on failed adjustments and probable faulty assemblies.
Steps for replacing an assembly in the E5052B.
Procedure for removing the outer cover of the instrument.
Procedure for removing the front panel assembly.
Procedure for removing the removable hard disk assembly.
Procedure for replacing the removable hard disk drive.
Procedure for replacing the power supply assembly.
Procedure for replacing the A26 digital bridge board.
Procedure for replacing the A25 24-bit I/O board.
Procedure for replacing the A21 PCI DSP and A24 GPIB cards.
Procedure for replacing the A32 USB (USBTMC) interface card.
Procedure for replacing the Oven CH1 assembly.
Procedure for replacing the Oven CH2 assembly.
Procedure for replacing the A57 DC block assembly.
Procedure for replacing the instrument fan.
Procedure for replacing the A22 power distribution board.
Procedure for replacing the A20 digital motherboard.
Procedure for replacing the A1 Freq/Power Detector Module.
Procedure for replacing the A2 DC Source Board.
Procedure for replacing the A3 ADC/DSP Board.
Procedure for replacing the A4/A5 Local Synthesize Module.
Procedure for replacing the A6 Phase Detector Board.
Procedure for replacing the A50 Analog Motherboard.
Procedure for replacing the control touch panel.
Procedure for replacing the A52 Inverter Assembly.
Procedure for replacing the A51 LCD.
Procedure for replacing the A22 Front Keyboard.
Procedure for replacing the Front USB PCA Board.
Procedure for replacing the Probe Power and Power Switch Board.
Procedure for replacing the front BNC connector.
Required procedures after replacing an assembly.
Returns the E5052B system to factory state.
Steps for factory recovery on E5052B with NM321 or higher HDD revision.
Steps for factory recovery on E5052B with NM320 or lower HDD revision.
Describes how to update the E5052B firmware.
Procedure for updating the E5052B firmware.
Lists and explains various error messages and their meanings.
To Next Page
