Appendix B 209
System Recovery
System Recovery
B. System Recovery
Step 6. Select Restore.
Figure 0-1 Activate Acronis Startup Recovery Manager
Step 7. A confirmation dialog box is displayed. Push the enter to select
Yes to start the recovery of
the factory backup. The recovery takes a few minutes depending on the amount of data.
Figure 0-2 Recover Factory Backup
Step 8. When the recovery is finished, push the enter select OK. The E5052B restarts
automatically.
Step 9. After restart, the screen for initial registration appears. Execute initial registration. For
information on the execution procedure, refer to “Initial Registration Procedure (HDD
Revision: NM320 or below)” on page 30.
Step 10. Execute the calibration of the touch screen. For information on the execution procedure,
refer to “Calibration of the Touch Screen” on page 32.
To Next Page
Loading...
