156 Chapter 6
Replacement Procedure
Oven CH1 Assembly Replacement
Oven CH1 Assembly Replacement
Tools Required
• TORX screwdriver, T10, T15, and T20
Removal Procedure
Refer to Figure 6-11 for this procedure.
Step 1. Remove the outer cover as described in “Outer Cover Removal” on page 136.
Step 2. Remove the three TORX T10 screws (item 1) fastening the oven ch1 assembly.
Step 3. Disconnect the RF cable (item 2) from the oven ch1 assembly.
Step 4. Disconnect the cable (item 3) from the power distribution board.
Step 5. Lift the oven ch1 assembly (item 4).
Step 6. Remove the two TORX T10 screws (item 5) fastening the C-bracket.
Step 7. Remove the three TORX T10 screws (item 6) fastening the C-bracket.
Step 8. Remove the oven ch1 (item 7).
Step 9. Remeve the L-bracket (item 8).
To Next Page
Loading...
