154 Chapter 6
Replacement Procedure
A32 USB (USBTMC) Interface Card Replacement
A32 USB (USBTMC) Interface Card Replacement
Tools Required
• TORX screwdriver, T10, T15, and T20
Removal Procedure
Refer to Figure 6-10 for this procedure.
Step 1. Remove the outer cover as described in “Outer Cover Removal” on page 136.
Step 2. Remove the three TORX T10 screws (item 1) fastening the angle.
Step 3. Remove two TORX T10 screws (item 2) fastening the PCI DSP card/GPIB card assembly
to the rear panel.
Step 4. Lift the USB (USBTMC) interface card (item 3) from the digital motherboard carefully.
Step 5. Remove the two TORX T10 screws (item 4) fastening the angle.
To Next Page
Loading...
