Keysight E5052B - Replacement Procedure

Chapter 6 143
Replacement Procedure
Removable Hard Disk Drive Replacement
6. Replacement Procedure
Figure 6-4 Removable Hard Disk Drive Removal
Replacement Procedure
Step 1. Replace the removable hard disk drive by inverse procedure of removal.
NOTE Fasten the TORX T10 screws (item 5) using a torque screwdriver (set to 1.02 N-m / 9.0
lb-in).
Fasten the TORX T10 screws (item 6) using a torque screwdriver (set to 0.50 N-m / 4.4
lb-in).
Step 2. Insert the hard disk into the slot.
Step 3. Turn the key to the left until it is locked, then remove the key.
Step 4. When the “Backup” in Spot Adjustment has been done, restore backup files onto the new
removable hard disk drive as described in “Restore Backup Files onto the New Removable
Hard Disk Drive” on page 144.
Step 5. If the “Backup” in Spot Adjustment has not been done, restore backup files onto the new
removable hard disk drive as described in “Adjustment for the New Removable Hard Disk
Drive” on page 144.
e5052bse1106
142
3
7
8
6
5
5