Keysight E5052B - Receiver if Gain;Flatness Adjustment; Receiver RF Flatness dir Adjustment

Chapter 3 49
Adjustment
Required Adjustment after Replacing Assembly
1. Chapter Title
2. Chapter Title 3. Adjustment
4. Chapter Title
5. Chapter Title
Receiver IF Gain/Flatness Adjustment
The purpose of this procedure is to adjust the IF gain / flatness of the A6 phase detector
board.
Required equipment for the receiver IF gain/flatness adjustment
Receiver RF Flatness Dir Adjustment
The purpose of this procedure is to adjust the RF flatness of the A6 phase detector board.
Required equipment for the receiver RF flatness adjustment
Description Recommended Model
Signal Generator Keysight E8257D with Opt. UNX, UNT, 1EA
without Opt. UNW, 1EH
50 ohm Termination Keysight 909C opt.012
Power Sensor Keysight E9304A Opt. H18 or Keysight E9304A
Opt. H19
Power Meter Keysight E4419A/B
Power Splitter Keysight 11667A
N(m)-N(m) Cable Keysight N6314A (p/n 8120-8862)
N(m)-N(m) Adapter Keysight p/n 1250-1475
Description Recommended Model
Signal Generator Keysight E8257D with Opt. UNX, UNT, 1EA
without Opt. UNW, 1EH
50 ohm Termination Keysight 909C Opt. 012
Power Sensor Keysight E9304A with Opt. H18 or Keysight
E9304A Opt. H19
Power Meter Keysight E4419A/B
Power Splitter Keysight 11667A
N(m)-N(m) Cable Keysight N6314A (p/n 8120-8862)
N(m)-N(m) Adapter Keysight p/n 1250-1475