136 Chapter 6
Replacement Procedure
Outer Cover Removal
Outer Cover Removal
Tools Required
• TORX screwdriver, T10,T15 and T20
Procedure
Refer to Figure 6-1 for this procedure.
Step 1. Disconnect the power cable from the E5052B.
Step 2. Remove the four bottom feet (item 1).
Step 3. Remove the four TORX T10 screws (item 2) from the bottom.
Step 4. Remove the four TORX T20 screws (item 3) fastening the side strap handles.
Step 5. Remove the four TORX T15 screws (item 4) fastening the four rear foot
Step 6. Remove the four TORX T15 screws (item 5) fastening the cover.
Step 7. Slide the outer cover and remove it carefully.
To Next Page
Loading...
