174 Chapter 6
Replacement Procedure
A4/A5 Local Synthesize Module Replacement
A4/A5 Local Synthesize Module Replacement
Tools Required
• TORX screwdriver, T10, T15, and T20
• Flat edge screwdriver
• Open-end torque wrench, 5/16 inch (set to 1.02 N-m / 9.0 lb-in) (for reconnecting SMA
connector)
Removal Procedure
Refer to Figure 6-20 for this procedure.
Step 1. Remove the outer cover as described in “Outer Cover Removal” on page 136.
Step 2. Remove the front panel as described in “Front Panel Removal” on page 138.
Step 3. Disconnect the semi-rigid cables (item 1).
Step 4. Remove each two TORX T10 screws (item 2) from the local synthesize module.
Step 5. Slide out the local synthesize module (item 3).
Step 6. Release the clamped cables from the clamp (item 4).
Step 7. Disconnect the RF cable (item 5) from the local synthesize module.
To Next Page
Loading...
