144 Chapter 6
Replacement Procedure
Removable Hard Disk Drive Replacement
Step 6. Calibrate the touch screen as described in “Calibration of the Touch Screen” on page 144.
WARNING From the volume label CN925, user recovery function is not prepared. It is required
to inform this change to user before replacing the hard disk drive.
Restore Backup Files onto the New Removable Hard Disk Drive
The backup files are stored into the PC. The file must be restored in the new removable
hard disk drive with the adjustment program. For the details of the adjustment program,
refer to Chapter 6 on page 133.
Step 1. Run the adjustment program.
Step 2. Perform the adjustment using “Recovery” in
Spot Adjustment of the program.
Adjustment for the New Removable Hard Disk Drive
Step 1. Run the adjustment program.
Step 2. Perform the adjustment using “HDD” in
Spot Adjustment of the program.
Calibration of the Touch Screen
When you have replaced the HDD on a E5052B equipped, you have to calibrate the touch
screen. Follow the procedure described below to calibrate the touch screen.
Step 1. Press .
Step 2. Press
Service Menu.
Step 3. Press
Test Menu.
Step 4. Press
Adjust Touch Screen.
The touch screen calibration screen (Figure 6-5) appears.
To Next Page
Loading...
