Keysight E5052B - Required Tools

Chapter 6 135
Replacement Procedure
Required Tools
6. Replacement Procedure
Required Tools
The following tools are required for repair of the E5052B.
Table 6-1 Required Tools
Assembly TORX screwdriver flat edge
screwdriver
10 mm
torque
wrench
cutting
Plier
hex key open-end torque wrench
T8 T10 T15 T20 1.5 mm 9/16
in.
5/8 in. 5/16
in.
Outer Cover 
Front Panel   
Removable Hard Disk
Assembly

Removable Hard Disk
Drive

Power Supply 
Digital Bridge 
24 bit I/O 
PCI DSP / GPIB  
USB Interface 
Oven CH1 
Oven CH2 
DC Block   
Fan     
Power Distribution 
Digital Motherboard  
Freq / Power Detector   
DC source   
ADC/DSP   
Local Synthesize   
Phase Detector   
Analog Motherboard    
Front Panel   
Control Touch Panel   
Inverter   
LCD   
Front Panel Keyboard    
Front USB PCA   
Probe Power and
Power Switch Board
 

Front BNC Connector     