Keysight E5052B - Phase Noise Accuracy Test

14 Chapter 1
General Information
Required Equipment
Required Equipment
Table 1-1 lists the recommended equipment for performing maintenance on the E5052B.
Table 1-1 Recommended Test Equipment
Equipment Critical specifications Recommended Model Qty.
Use
*1
Signal Generator Frequency: 10 MHz to 7 GHz
Low SSB Phase Noise
Keysight E8257D
with Opt. UNX, UNT, 1EA
without Opt. UNW, 1EH
1P,A
Network Analyzer Frequency: 10 M to 3 GHz Keysight E5070B/71B 1 P
Power Meter No Substitute Keysight E4419B 1 P,A
Power Sensor No Substitute Keysight E9304A Opt.
H18
1P,A
Power Amplifier Gain: 35 dB,
Freq range: 10M to 3 GHz
R&K A3000-2H-R 1 P,A
Power Amplifier Gain: 35 dB,
Freq range: 3 G to 7 GHz
Keysight 83020A 1 P,A
Multimeter No Substitute Keysight 3458A 1 P,A
Function Generator No Substitute Keysight 33250A 1 A
Calibration Kit Frequency: 10 M to 7 GHz Keysight 85032F 1 P
Frequency Counter Frequency: 10 MHz Keysight 53181A Opt.010 1 T
Step Attenuator Attenuator range: 0 dB to 50 dB
Step: 10dB,
Freq range: 10 M to 7 GHz
Keysight 8496H 1 P,A
Blocking Capacitor No Substitute Keysight 11742A 1 P,A
Power divider No substitute Keysight 11636A 1 P
Fixed attenuator (3
dB)
50 Ω, N(m)-N(f), 3 dB Keysight 8491A Opt.003 2 P,A
Power Splitter N(f) 50 Ω in, N(f) 50 Ω out Keysight 11667A 1 P,A
Band Pass Filter 70 MHz, Band width 10 kHz FILTRONETICS
FN-2063M
1P
Low Pass Filter 70 MHz Mini-Circuits SLP-70 1 A
Resistor 141 Ω, 1 W Keysight p/n 0698-3615
(47ohm), 3 ea
1P, A
Feed Thru
Termination
50 Ω, 1W Keysight 04192-61002 1 A
50 Ω Termination 50 Ω (N) Keysight 909C Opt. 012 1 A