142 Chapter 6
Replacement Procedure
Removable Hard Disk Drive Replacement
Removable Hard Disk Drive Replacement
Tools Required
• TORX screwdriver, T10
• Torque screwdriver, TORX T10
Save Backup Files to the PC
When the removable hard disk drive is readable, you have to perform the following steps.
For details of the adjustment progra, refer to Chapter 6 on page 133.
Step 1. Run the adjustment program.
Step 2. Perform the adjustment using “Backup” in
Spot Adjustment of the program.
Removal procedure
Refer to Figure 6-4 for this procedure.
Step 1. Insert the key (P/N 1390-1375) in the lock and turn clockwise (item 1).
Step 2. Loosen a screw (item 2).
Step 3. Press the button under the screw (item 3) and remove the hard disk (item 4).
Step 4. Remove the four TORX T10 screws (item 5), and remove the removable hard disk drive’s
lid (item 6).
Step 5. Remove the four TORX T10 screws (item 7) fastening the HDD bracket and remove it.
Step 6. Remove the hard disk drive (item 8) from the connector board.
To Next Page
Loading...
