208 Appendix B
System Recovery
System Recovery
Procedure to execute the factory recovery (HDD Revision: NM320 or
below)
This section describes how to return the contents of the C drive to the factory state.
NOTE You need a keyboard for this operation.
Step 1. Shut down the E5052B.
Step 2. Disconnect all of the USB device from the USB ports.
Step 3. Connect the keyboard to the E5052B.
Step 4. Press the standby switch of the E5052B to turn it on.
Step 5. When the screen as shown in the figure below appears, press of the keyboard.
CAUTION Press F11 only once. If you press F11 twice or more and a screen which is not mentioned in
this manual appears, reboot the instrument and restart the process from the first.
NOTE After several seconds, the next screen appears automatically even if you do not press any
key, so do not miss it.
NOTE After Step 5, if the E5052B freezes with the cursor does not blink, turn the power off and
remove unnecessary USB devices. Then, replace the keyboard with a PS/2 keyboard to
execute the process again.
e5071cse1055
Starting Acronis Loader...
Press F11 for Acronis Startup Recovery Manager...
To Next Page
Loading...
