Keysight E5052B - Phase Noise BW Adjustment; FLL BW Adjustment

Chapter 3 43
Adjustment
Required Adjustment after Replacing Assembly
1. Chapter Title
2. Chapter Title 3. Adjustment
4. Chapter Title
5. Chapter Title
Required Adjustment after Replacing Assembly
After replacing the following assembly, the adjustment items described in Table 3-1 must
be required. The adjustment must be performed by Keysight’s qualified service personnel.
If you need the adjustment for your E5052B, it should be sent to the nearest Keysight
Technologies service office.
Writing ID
This item writes the serial number and the option structure into the E5052B.
Required equipment for the writing ID
None
Table 3-1 Required Adjustment Item after Replacing Assembly
Replaced Assembly Adjustment Item
Writing ID DC Control Voltage Adjustment DC Power Voltage Adjustment DC Power Current Adjustment Reference Frequency Adjustment Pre-LO Sampler PLL BW Adjustment Receiver DC offset Adjustment PM Offset Adjustment PM Linearity Adjustment PM Temp Adjustment PM Flatness Adjustment Receiver RF Flatness Adjustment Receiver IF Gain/Flatness Adjustment Receiver RF Flatness Dir Adjustment Receiver IF Gain/Flatness Dir Adjustment LO Sampler PLL BW Adjustment Phase Noise BW Adjustment FLL BW Adjustment
A1 Freq/Power Det.
 
A2 DC Source

A3 ADC/DSP
 
A4/A5 Local Synt
 
A6 Phase Det
 
HDD
 
A21 PCI DSP Card
