228 Appendix B
System Recovery
Initial Registration of E5052B
Initial Registration of E5052B
When you start up the E5052B at the first time, you need to perform the initial registration
of the Windows XP operating system of the E5052B. There are two procedures in
accordance with the HDD revision.
NOTE It is not possible to check the HDD revision installed on your E5052B before Windows is
booted. Therefore, you should follow the procedure which you see on the unit.
NOTE You cannot use the front panel keys during the initial registration of the E5052B therefore
connect the mouse and the keyboard before turning on the power.
NOTE If you perform the following procedure incorrectly, a message asking you whether to return
to the previous registration screen and perform the registration appears. In this case, follow
the instruction to return to the previous registration screen.
Initial Registration Procedure (HDD Revision: NM321 or above)
Step 1. Turns on the E5052B.
Step 2. The Windows XP Professional Setup wizard appears. Click the
Next > button (Figure B-5).
Figure B-5 Windows XP Professional Setup wizard
To Next Page
Loading...
