148 Chapter 6
Replacement Procedure
A26 Digital Bridge Board Replacement
A26 Digital Bridge Board Replacement
Tools Required
• TORX screwdriver, T10, T15, and T20
Removal Procedure
Refer to Figure 6-7 for this procedure.
Step 1. Remove the outer cover as described in “Outer Cover Removal” on page 136.
Step 2. Remove the three TORX T10 screws (item 1) fastening the angle.
Step 3. Disconnect the flat cable (item 2) from the PCI DSP card.
Step 4. Disconnect the flat cables (item 3) from the digital bridge board.
Step 5. Remove the two TORX T10 screws (item 4) fastening the board to the rear panel.
Step 6. Lift the digital bridge borad (item 5).
Step 7. Disconnect the cables (item 6) from the digital bridge board.
Step 8. Remove the two TORX T10 screws (item 7) fastening the angle.
To Next Page
Loading...
