146 Chapter 6
Replacement Procedure
Power Supply Assembly Replacement
Power Supply Assembly Replacement
Tools Required
• TORX screwdriver, T10, T15, and T20
Removal Procedure
Refer to Figure 6-6 for this procedure.
Step 1. Remove the outer cover as described in “Outer Cover Removal” on page 136.
Step 2. Remove the three TORX T10 screws (item 1) from the rear panel.
Step 3. Disconnect the power supply cables (item 2).
Step 4. Remove the two TORX T20 screws (item 3) fastening the plate for power supply.
Step 5. Lift the power supply assembly toward front side.
To Next Page
Loading...
