140 Chapter 6
Replacement Procedure
A27 Removable Hard Disk Assembly Removal
A27 Removable Hard Disk Assembly Removal
Tools Required
• TORX screwdriver T10, T15 and T20
Removal Procedure
Refer to Figure 6-3 for this procedure.
Step 1. Remove the outer cover as described in “Outer Cover Removal” on page 136.
Step 2. Release the clamped cable form the clamp (item 1) on the bracket HDD.
Step 3. Remove the two TORX T10 screws (item 2, 3) fastening the bracket HDD.
Step 4. Release the cables from the removable hard disk assembly (item 4).
Step 5. Lift the removable hard disk assembly.
Step 6. Remove the four TORX T10 screws (item 5) fastening the bracket HDD.
To Next Page
Loading...
