Keysight U1271A - Calibration Error Codes; Table 1-4 Calibration Error Codes

1 Calibration Procedures
48 Keysight U1270 Series Service Guide
Calibration Error Codes
The following errors indicate failures that may occur during a calibration.
Table 1-4 Calibration error codes
Code Descriptions
Er002 Calibration error: secure code invalid
Er003 Calibration error: serial number code invalid
Er004 Calibration error: calibration aborted
Er005 Calibration error: value out of range
Er006 Calibration error: signal measurement out of range
Er007 Calibration error: frequency out of range
Er008 EEPROM write failure