SIEGENIA access control systems
IO module/IO module smart
05.20204/24 H39.ELEKS010EN-00
1
begin the assembly work. Follow the notes in Chapter 2
"Safety", in order to prevent personal injury or mal-
-
ule/IO module smart and must be accessible to the
1.1 Producer and service
KFV Karl Fliether GmbH & Co. KG
A company of the SIEGENIA GROUP
Siemensstraße 10
42551 Velbert
Tel.: +49 2051 278-0
Fax: +49 2051 278-167
E-mail: info@kfv.de
Please contact your contractual partner in case of com-
1.2
-
ists only. All work described in this document is to be
performed only by experienced professionals with
commissioning and maintenance of electromechanical
components.
All work on a 230 V AC mains power supply may only
1.3 Intended use
• The IO module/IO module smart serves as an inter-
face for electromechanical locking and unlocking
systems (e. g. A-opener, GENIUS A and GENIUS B/
Panic).
• The IO module/IO module smart is intended for
indoor use (IP20) with a room temperature of 0°C to
-
ed boxes or surface mounted in approved branch
boxes.
•
• Use the IO module/IO module smart only when it is
• Repair of the IO module/IO module smart is not
permissible. The IO module/IO module smart must
be replaced in case of faults.
1.4 Improper use
• The IO module smart must not be installed in a
metal casing, as this could lead to shielding of the
WIFI signal.
• The IO module/IO module smart must not be used
in event of air humidity > 80 %. The unit is not
approved for use in swimming pools and/or wet
• The IO module/IO module smart and its connected
electromechanical components must not be tam-
1.5 Maintenance and service notes
Never use cleaning agents that are aggressive or con-
tain solvents. This could damage the surfaces of the
components.
1.6
1.7 Dimensions
All measurements are given in mm.
1.8 Symbols used
The following icons are used in this document:
general warning symbol
the corresponding point
To Next Page
Loading...