797
Maintenance
Rear fog light (if equipped)
1. Remove the under cover by rotating
the screws.
2. Reach your hand into the back of the
rear bumper.
3. Disconnect the power connector.
4. Remove the bulb-socket from the
housing by turning the socket counter
clockwise until the tabs on the socket
align with the slots on the housing.
5.Install the new bulb-socket into the
housing by aligning the tabs on the
socket with the slots in the housing.
Push the socket into the housing and
turn the socket clockwise.
6.Connect the power connector.
7.Reinstall the rear under cover.
✽✽
NOTICE
Rear fog light is only on the driver’s side
(5 door, if equipped).
OJD073075
OJD075071
OJD073074
To Next Page
Loading...
