Kia EV6 2022 - Advanced Driver Assistance Systems (ADAS); 3 D Surround View Monitor (SVM)

35
†LEGAL DISCLAIMERS ON BACK INSIDE COVER | *IF EQUIPPEDALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
Rear View Monitor is a supplemental system that displays the view behind the vehicle
through the infotainment system screen while the vehicle is in Reverse.
To turn RVM on/off, press the Parking/View button
F
on the center console.
RVM User Settings:
• Camera Settings - Press the SETUP key/button on the Infotainment System. Select
VEHICLE, DRIVER ASSISTANCE, PARKING SAFETY, then CAMERA SETTINGS
• To adjust the warning volume, press the SETUP key/button on the Infotainment System,
VEHICLE, DRIVER ASSISTANCE, then WARNING VOLUME. Select high, medium, low
The Rear View Monitor activates when the:
• POWER button is in the ON/READY position
• Rotary Dial Shifter Knob is in the R (Reverse) position
Rear View Monitor (RVM)
†4
ADAS
ADVANCED DRIVER ASSISTANCE SYSTEMS (ADAS)
Remote Smart Parking Assist (RSPA)*
†4
(Continued)
REMINDERS:
• The images shown are for illustration purposes only and may not re󲛶ect actual operation
• While camera is active, only the Infotainment System can be operated on the Steering Wheel and Audio
Head Unit. All other features are disabled
• Rear View Monitor may not display every object behind the vehicle
• Adjusting the Warning Timing and Warning Volume may adjust timing and volume levels for other
driving assist systems
• Through normal use and after inclement weather or washing, the rear camera may become dirty. Use a
clean, micro󲛵ber cloth to remove any dirt, debris or spots that have accumulated on the lens
When engaged, RVM is not a substitute for proper and safe backing-up procedures. Rear View Monitor
may not display every object behind the vehicle. Always drive safely and use caution when backing up.
Smart Exiting:
• Press and hold the Parking/View button
A
to turn on
Smart Exiting
• Select either left or right exiting
• Take your hands off the steering wheel to allow RSPA to
operate
• Then press and hold the Parking/View button
A
while
RSPA is operating - hold the button until the vehicle has
󲛵nished exiting
To turn off RSPA at any point while it’s operating, press the
Parking View button
A
or Parking Safety button
B
, press the
Park button on the Rotary Dial Shifter
F
or press the Remote
Start button
C
on the Smart Key.
To adjust the warning volume, press the SETUP key/button on
the Infotainment System, VEHICLE, DRIVER ASSISTANCE then
WARNING VOLUME. Select high, medium, low (this will adjust
the warning volume for other driver assistance features).
REMINDERS:
• Remote Smart Parking Assist will only operate if you are within 13 feet
of the vehicle, with the Smart Key in your possession
• Remote Smart Parking Assist will not function when:
- There is a parking space open, with a vehicle on one side only
- When trying to park in a diagonal space
- When the parking space is too narrow or near a wall
EV
R
N
P
AUTO
HOLD
D
(Button located below gear shift knob)
F