REMOVAL
1.
Remove the windshield wiper arm and blade after removing the 2 nuts.
Care must be taken not to scratch the engine hood.
Tightening torque :
19-28Nm (190-280kg·cm, 14-20.6lb·ft)
2.
Remove the weather strip and the cowl top cover then remove the 5 bolts holding the linkage.
Tightening torque :
4-6Nm (40-60kg·cm, 2.9-4.4lb·ft)
Disconnect the windshield wiper motor connector and remove the windshield wiper motor and the linkage.
INSTALLATION
1
Install the wiper arm to the specified position.
To Next Page
