19
3
3
Safety features of your vehicle Seat belts
Rear passenger’s seat belt warn
-
ing (if equipped)
As a reminder to the rear passenger, the
rear passenger’s seat belt warning lights
will appear for approximately 6 seconds
each time you turn the ignition switch
ON regardless of belt fastening.
If the seat belt is not fastened when the
ignition switch is turned ON, the seat
belt warning light will appear for approx
-
imately 70 seconds.
If you start to drive without the seat belt
fastened or you unfasten the seat belt
when you drive under 20km/h, the cor
-
responding warning light will continue to
appear for approximately 70 seconds.
If you continue to drive without the seat
belt fastened or you unfasten the seat
belt when you drive over 20km/h, the
seat belt warning chime will sound for
approximately 35 seconds and the cor
-
responding warning light will blink.
If the rear door is opened and closed
under 10km/h, warning light and warn
-
ing chime does not work even if driving
over 20km /h.
Lap/Shoulder belt
Height adjustment
Front seat
You can adjust the height of the shoul
-
der belt anchor to one of 4 positions for
maximum comfort and safety.
The height of the adjusting seat belt
should not be too close to your neck.
Otherwise, you will not be getting the
most effective protection. The shoulder
portion should be adjusted so that it lies
across your chest and midway over your
shoulder near the door and not your
neck.
To adjust the height of the seat belt
anchor, lower or raise the height
adjuster into an appropriate position.
To raise the height adjuster, pull it up (1).
To lower it, push it down (3) whilst press
-
ing the height adjuster button (2).
Release the button to lock the anchor
into position. Try sliding the height
adjuster to make sure that it has locked
into position.
僅 Verify the shoulder belt anchor is
locked into position at the appropriate
height. Never position the shoulder
belt across your neck or face. Improp
-
To Next Page
