6
Solo-baric L5 Enclosures
Installation
After determining the best mounting position, carefully check
the areas where the mounting brackets will be placed. Make sure
the mounting screws will not puncture the gas tank, brake lines,
wiring, or interfere with any mechanical parts on the underside of
the mounting surface. Turn the enclosure upside-down, pre-drill
the holes using a 7/64” (2.5 mm) bit and attach the four mounting
brackets to the bottom of the enclosure using the supplied
smaller screws. Each bracket must be positioned so the rounded
end protrudes approximately 3/4" (2 cm) from under the cabinet
to allow a screw to easily pass through the bracket, securing the
enclosure to the vehicle.
Plug your subwoofer speaker wire into the terminals, using the
red connector as positive and the black connector as negative.
Hook the other end of the wire to your subwoofer amplifier in
accordance with its owner's manual.
CAUTION: This enclosure is internally wired for a 2 or 4
ohm load at the speaker-wire connection terminal. Please
refer to the terminal or the box packaging for your
enclosure’s specific impedance. Make sure your amplifier
can drive this load.
With the enclosure right side up, securely attach it to the
vehicle with the supplied larger screws.
If the supplied hardware is not applicable to your installation,
some other means of securely attaching the enclosure to the
vehicle must be used.
WARNING: To avoid potential injury, or
possible death, from forward movement of
the enclosure during abrupt stops or
accidents, the enclosure must be
properly installed and securely fastened
to your vehicle.
To Next Page
Loading...
