7
Solo-baric L5 Enclosures
Installation
Sealed Enclosures
TS Series sealed enclosures combine KICKER’s award
winning Solo-Baric subwoofers with computer-modeled and
human fine-tuned enclosures to offer a level of bass performance
never before thought possible from a commercially available,
ready-to-install subwoofer system. The TS Series enclosures are
available with a pre-loaded 10 inch Solo-Baric L5.
To get all the amazing performance potential from your new
enclosure, you need to follow some basic rules. Please read
these instructions carefully. Then, you will be ready to install the
subwoofer enclosure and be on the road and “Livin’ Loud™”.
Kicker TS Series enclosures are designed to fit behind the seat
of a pickup truck. They are engineered to provide the best bass
response when firing into the back of the truck seat.
Plug your subwoofer speaker wires into the terminals. The red
connectors are positive and the black connectors negative. Hook
the other end of these wires to your subwoofer amplifier in
accordance with the amplifier’s manual.
CAUTION: This enclosure is internally wired for a 2 or 4
ohm load at the speaker-wire connection terminal. Please
refer to the terminal or the box packaging for your
enclosure’s specific impedance. Make sure your amplifier
can drive this load.
All specifications and performance figures are subject to change. Please visit kicker.com for the most current information.
Note: To get the best performance from your Solo-Baric L5
subwoofer enclosure, we recommend using genuine Kicker
Accessories and Wiring.
To Next Page
Loading...
