Need help?Do you have a question about the Kicker Solo X S18XSP Spair and is the answer not in the manual?
Remove the four acorn head nuts and eight bolts securing the SPAIR to the BAM.
Install the Gap Cap into the BAM around the pole-piece to protect the motor assembly from debris.
Test all four possible SPAIR/BAM rotational combinations for rubbing or interference issues.
Mark the SPAIR and BAM with tape or pen to identify the combination without rubbing.
Connect speaker wires to the SPAIR, ensuring the Locator Hole aligns with the Locator Pin on the BAM.
Insert the SPAIR into the BAM, aligning it correctly, and then secure it with the provided hardware.
To Next Page
General