Need help?Do you have a question about the Kicker SOLOX and is the answer not in the manual?
Removable soft parts assembly for easier installation and repair.
Secures SPAIR to BAM for a tight seal and proper performance.
Centering cap for voice coil and improved heat dissipation.
Stitching prevents surround separation from cone at high excursions.
Inverted dome provides structural support to resist cone buckling.
Dual coils for high excursion, power handling, and flexible wiring.
Enhances heat dissipation, lowers operating temp, and controls cone motion.
Explains why break-in is crucial for optimal low bass response and performance.
Step-by-step guide for breaking in the speaker in free air.
Lists recommended enclosure volumes for different applications.
Lists advantages of sealed enclosures, like high power handling and smooth rolloff.
Lists disadvantages of sealed enclosures, like lower efficiency.
Details three recommended ported enclosure designs for different applications.
Lists advantages of vented enclosures, like increased output and "bump".
Lists disadvantages of vented enclosures, like loss of cone control and sensitivity.
Wiring configuration for connecting two voice coils in parallel.
Wiring configuration for connecting two voice coils in series.
Formula for calculating total resistance in series connection.
Formula for calculating total resistance in parallel connection.
Describes connecting wires using binding posts.
Describes connecting wires using a barrier strip.
Describes connecting wires using a terminal block.
Instructions for obtaining warranty service and returns.
Lists exclusions from warranty coverage.
Information on service turnaround time.
Guidance for international warranty claims.
Details parts not covered by warranty for SPAIR and BAM.
Specifies what aspects of the BAM are covered by warranty.
Important note regarding RMA and shipping for warranty claims.
To Next Page
General
