8
5. Introduction, Product Features and Specifications
INTRODUCTION
This alarm detects products of combustion using photoelectric technology and carbon monoxide using an
electrochemical cell. Many times throughout this User Guide, we will refer to Carbon Monoxide as “CO.” Ten (10)
years after the unit is installed, this unit will automatically alert you that it is time to replace the unit. This is called
“End of Unit Life” mode. See Troubleshooting Guide. To help identify the date to replace the unit, a label has
been affixed to the side of the alarm. Write in the “Replace by” date (10 years from initial power up) in permanent
marker on the label prior to installing the unit.
NOTE: AC power must be connected to obtain the full 10 year battery and unit life.
PRODUCT FEATURES AND SPECIFICATIONS:
• Temperature: Operating Range: 4.4°C (40°F) to 37.8°C (100°F)
• Humidity: Operating range: 10-95% RH non-condensing
• Audible Alarm: 85+ dB at 10’ 3.0 to 3.5 KHz pulsing alarm, with voice messages
“Fire!” and/or “Warning! Carbon Monoxide.”
• Smoke Sensor: Photoelectric
• CO Sensor: Electrochemical
• Voice message system
• Smoke Alarm Hush
®
Control
• Ambient Light Sensing
• Powered by 120 V AC (60 Hz, 53 mA max) wire-in connector with sealed lithium battery backup.
• Hardwire interconnectable to other compatible alarms.
• One large, user- friendly button.
To Next Page
Loading...
