tion of the “ON” arrow on the cover until the alarm ratchets into
place (this ratcheting function allows for aesthetic alignment).
7. Turn on the AC power. The green AC Power On Indicator
should be lit when the alarm is operating from AC power.
TAMPER RESIST FEATURE: To make your smoke alarm tamper
resistant, a tamper resist feature has been provided. Activate the
tamper resist feature by breaking off the four posts in the square
holes in the trim ring (see figure 6). When the posts are broken
off, the tamper resist tab on the base is allowed to engage the
mounting bracket. Rotate the alarm onto the trim ring until you
hear the tamper resist tab snap into place, locking the alarm on
the trim ring. Using the tamper resist feature will help deter chil-
dren and others from removing the alarm from trim ring. NOTE:
To remove the alarm when the tamper resist tab is engaged, press
down on the tamper resist tab, and rotate the alarm off of the
trim ring (see figure 7).
After installation, TEST your alarm by pressing and holding the test
button for several seconds. This should sound the alarm.
A
A
FIGURE 5
FIGURE 6
Posts
FIGURE 7
1475-7205-00(820-0905-EN)_R1.indd 81475-7205-00(820-0905-EN)_R1.indd 8 2009.12.9 10:07:37 AM2009.12.9 10:07:37 AM
To Next Page
Loading...
Need help?
General
