Kidde PI2010

For your convenience, write down the following
information. If you call our Consumer Hotline,
these are the first questions you will be asked.
Smoke Alarm Model Number
(located on back of alarm):
Date Code (located on back of alarm).
National Fire Protection Association
(NFPA) and the manufacturer
recommends replacing this alarm
ten years from the date code:
Date of Purchase:
Where Purchased:
AC Wire-in Single and/or Multiple Station (up to 24 Devices)
Photoelectric/Ionization Smoke Alarm with 9 Volt Battery
Back Up and “HUSH” Control to temporarily silence nuisance
alarms.
Thank you for purchasing this smoke alarm. It is an important part of
your family’s home safety plan. You can trust this product to provide
the highest quality safety protection. We know you expect nothing less
when the lives of your family are at stake. Kidde alarms and accessories
CAN ONLY BE interconnected with other Kidde alarms and accessories
as well as specified brands and models of interconnect compatible
alarms. Connection of Kidde products to a non-specified manufactur-
er’s interconnect system, or connection with non-specified equipment
from another manufacturer into an existing Kidde system could result
in nuisance alarming, failure to alarm, or damage to one or all of the
devices in the interconnect system. Refer to the User’s Guide supplied
with each Kidde product for interconnect compatible models, brands,
and devices. Refer to the wiring instructions in section 3 for NFPA initi-
ating device limits.
Smoke Alarm User’s Guide
820-0905 REV. D 06/09
1475-7205-00
PI2010
For model: PI2010
1475-7205-00(820-0905-EN)_R1.indd 11475-7205-00(820-0905-EN)_R1.indd 1 2009.12.9 10:07:36 AM2009.12.9 10:07:36 AM

Kidde PI2010 Specifications

General

Type	Photoelectric
Alarm Volume	85 dB
Test/Silence Button	Yes
LED Indicator	Yes
Interconnect	No
Hush Feature	Yes
Low Battery Indicator	Yes
Weight	0.5 lbs
Power Source	Battery-operated

Summary

Recommended Locations for Smoke Alarms

Locations to Avoid

Installation Instructions

Wiring Requirements

Details electrical and interconnect wiring specifications and standards.

AC Quick Connect Harness Wiring

Step-by-step instructions for connecting the AC quick connect harness.

Mounting Instructions

Steps for physically attaching the smoke alarm to the ceiling or wall.

Battery Installation and Removal

Procedure for installing and replacing the backup battery.

Operation and Testing

Hush Control

Temporarily silences nuisance alarms caused by cooking or steam.

LED Indicators

Explanation of the red and green LED lights and their meanings.

Low Battery Condition

How to identify and respond to a low battery warning chirp.

Testing the Alarm

Procedure for weekly testing to ensure proper alarm function.

Nuisance Alarms

Maintenance

Alarm Removal

Instructions on how to safely remove the smoke alarm from its mounting.

Cleaning Your Alarm

Procedure for cleaning the smoke alarm annually for optimal performance.

Limitations of Smoke Alarms

Good Safety Habits

Develop and Practice a Plan of Escape

Steps for creating and practicing a home fire escape plan.

NRC Information

NFPA Required Protection

California State Fire Marshal Caution

Service and Warranty