What to do if my Kidde Smoke Alarm is at the end of its life?
When your Kidde Smoke Alarm reaches the end of its life: * Push/release the Test/Hush button to temporarily silence it (see the End of Unit Life Hush Mode section). * Remove, discharge, and dispose of the unit, then replace it as soon as possible.
What to do when Kidde P4010ACSCO is in End of Unit Life Hush® Mode?
When your Kidde Smoke Alarm is in End of Unit Life Hush® Mode (after pushing/releasing the Test/Hush® button during End of Life): * Remove, discharge, dispose of the unit, and replace it as soon as possible. * 7 days after End of Unit Life chirps begin, the red LED will blink an error code (number of blinks) when the Test/Hush® button is pushed/released once. Report the number of blinks to customer service if needed.
What to do if my Kidde P4010ACSCO is in Fault Mode?
If your Kidde Smoke Alarm is in Fault Mode: * Refer to the Cleaning Your Alarm section. * Push the Test/Hush button once to attempt to reset the unit. * The red LED will blink an error code (number of blinks) when the Test/Hush button is pushed/released once. Report the number of blinks to customer service if needed.
Guidance on silencing smoke alarms when the cause is known and not life-threatening.
Information on the low battery monitor circuit and replacement timeline for continuous protection.
Instructions for creating and practicing a home escape plan for emergencies.
Details the limited warranty period, coverage, and exclusions for the alarm.
General| Model | P4010ACSCO |
|---|---|
| Voice Alerts | Yes |
| Test/Silence Button | Yes |
| End of Life Signal | Yes |
| Wireless Interconnect | No |
| Hush Feature | Yes |
| LED Indicator | Yes |
| Mounting | Ceiling or Wall |
| Type | Combination Smoke and Carbon Monoxide Alarm |
| Battery Backup | Yes |
| Interconnectable | Yes |
| Alarm Sound | 85 dB |
| Warranty | 10 Years |
| Sensor Type | Electrochemical (CO), Photoelectric (Smoke) |
To Next Page
