Kidde VM-1 - Page 153

Chapter 7: Service and troubleshooting
P/N 3101890-EN • REV 006 • ISS 21JUN18 145
Address
Label Source Description
0715
Ctrl Center Enabled Port 1 CPU A control center connected through the Port 1
gateway has been enabled by an access level
override.
0716
Ctrl Center Enabled Port 2 CPU A control center connected through the Port 2
gateway has been enabled by an access level
override.
0717
Ctrl Center Enabled IP
Service 1
CPU A control center connected through the gateway for
IP ServiceID 1 has been enabled by an access level
override.
0718
Ctrl Center Enabled IP
Service 2
CPU A control center connected through the gateway for
IP ServiceID 2 has been enabled by an access level
override.
0719
Ctrl Center Enabled IP
Service 3
CPU A control center connected through the gateway for
IP ServiceID 3 has been enabled by an access level
override.
0720
Ctrl Center Enabled IP
Service 4
CPU A control center connected through the gateway for
IP ServiceID 4 has been enabled by an access level
override.
0721
Ctrl Center Enabled IP
Service 5
CPU A control center connected through the gateway for
IP ServiceID 5 has been enabled by an access level
override.
0722
Ctrl Center Enabled IP
Service 6
CPU A control center connected through the gateway for
IP ServiceID 6 is active
0723
Ctrl Center Enabled IP
Service 7
CPU A control center connected through the gateway for
IP ServiceID 7 has been enabled by an access level
override.
0724
Ctrl Center Enabled IP
Service 8
CPU A control center connected through the gateway for
IP ServiceID 8 has been enabled by an access level
override.
Table 56: Nonsupervised output pseudo points
Address
Label Source Description
0621
Manual Answer Control DACT The module answers incoming calls
Table 57: Local relay pseudo points
Address
Label Source Description
0003
Channel 1 Relay
Confirmation
ACHS The panel changes to the active state when the
amplifier’s input relay selects channel 1
0004
Channel 2 Relay
Confirmation
ACHS The panel changes to the active state when the
amplifier’s input relay selects channel 2
0005
Channel 3 Relay
Confirmation
ACHS The panel changes to the active state when the
amplifier’s input relay selects channel 3
0006
Channel 4 Relay
Confirmation
ACHS The panel changes to the active state when the
amplifier’s input relay selects channel 4