KIDDY Evolution Pro 2 - Use in the Vehicle; In-Vehicle Installation with Seat Belt; Seat Selection for Seat Belt Installation; Installation Steps with the Seat Belt

13
EN
7. Use in the vehicle
7.1 In-vehicle installation with seat belt
7.1.1 Seat selection
Read up all the necessary information about the use of
child restraint systems in your vehicle owner’s manual.
e Evolution Pro 2 child restraint system can be installed on any seat
of vehicles equipped with a 3-point belt system (g. 11).
If you want to install the child restraint system in the pas-
senger seat, the airbag must be deactivated or you will
have to use a dierent seat.
7.1.2 Installation steps with the seat belt
WARNING
1. Place the Evolution Pro 2 facing the rear and with
the handle in the carry position on a seat without an
active front airbag and with a 3-point belt (g. 12).
2. Before starting the journey, please always make
sure that the harness is put on and tightened cor-
rectly.
Pull the vehicle seat belt out and feed the lap belt through both lap
belt guides and press the safety belt lock tongue into the buckle
(g. 13) with a clearly audible click. Check that everything is locked
into place. Tighten the lap belt (g. 13). Now place the shoulder belt
around the infant carrier and feed it through behind the front cover