KIDDY Evolution Pro 2 - Remove and Replacing the Covers; Removing the Sunshade

17
EN
3. is infant carrier is not intended for longer peri-
ods of sleeping.
4. It is dangerous to use this reclined infant carrier
on an elevated surface, e.g. a table.
5. Always use the restraint system.
6. Do not use the infant carrier if any components
are broken or missing.
7. Do not use accessories or replacement parts oth-
er than those approved by the manufacturer.
8. is child seat does not replace a cot or a bed.
Should your child need to sleep, then it should be
placed in a suitable cot or bed.
10. Remove / Replacing the covers
10.1 Removing the sunshade
Detach the outside loops on both sides of the car seat (g. 24, no. 1).
Press the attachment clips together (g. 24, no. 2) and remove the
sunshade by pulling upwards. (g. 24, no. 3). Remove the fabric can
-
opy from the gap between and around the headrest of the car seat.
To remove the fabric from the sunshade frame detach the loops from
each attachment clips (g. 24, no. 4). Hold the sunshade frame and
turn one of the attachment clips (g. 24, no. 5) and pull it o the frame
downwards. en pull the fabric o the frame.