13
13. Locate the hook behind the seat.
Lower the seat down into the
vehicle. Rock the seat backward to
insert the hook into the slot in the
vehicle. Push bottom of seat
toward the back of the
vehicle.
14
14. Locate hardware bag labeled “E”.
Using a Phillips screwdriver, insert a
self-tapping screw in the hole at the
front of the seat. Do not overtighten.
Repeat steps 13-14 to install the
other seat.
Install Seats
12. Spoiler: Locate hardware
bag labeled “F”. Locate
the four holes to secure
the spoiler. Insert four
self-tapping screws in the
holes and up through the
four posts in the spoiler.
Tighten with a Phillips
screwdriver.
DO NOT USE POWER
DRILL. Do not
overtighten hardware.
Assemble the Corvette
12
2 Holes
2 Holes
F
E
１２
To Next Page
Loading...
