Assemble the Corvette Race Car
1
1. Slide a large washer onto the axle.
NOTE: Washer may already be on
the axle.
Locate a wheel marked “FRONT”.
Slide a wheel onto the axle with
“FRONT” facing toward vehicle.
Then slide a wheel cover onto the
axle, fitting the three locating pins
into the holes.
2
2a
2. Slide a small washer onto the axle.
Attach a nut onto the axle and
tighten snugly with the nut wrench
until you can see about two threads
on the axle. Do not overtighten.
Repeat steps 1 and 2
to attach the other
front wheel.
Attach Front Wheels
５
To Next Page
Loading...
