PLZ-4W Basic Operation 5-17
4. Select the voltage range.
Press the VRANGE (SHIFT+RANGE) key.
A voltage range pop-up menu appears.
Each time you press the VRANGE key, the voltage range switches
between 15 V and 150 V.
When the desired range is highlighted, stop pressing the key.
5.
Set the voltage value.
Check that the display is in the basic setting entry condition (the characters
“SET” is highlighted).
While viewing the display, turn the rotary knob.
First, use coarse adjustment to roughly set the value, and then switch to fine
adjustment to adjust the value precisely.
6.
Turn on the load.
Press the LOAD key.
The LOAD LED illuminates, and the current flows.
The display shows the measured values (voltage, current, and wattage)
at the load input terminal.
7.
Change the voltage setting.
Turn the rotary knob to change the voltage setting.
The voltage value cannot be set greater than the maximum value of the
selected range.
8.
Turn off the load.
Press the LOAD key.
The LOAD LED turns off, and the current is cut off.
To Next Page
Loading...
Need help?
General
