Why TOS6200 Test Equipment by Kikusui does not start up?
The TOS6200 may not start up because a cross cable is being used as the interface cable. Also, ensure that the RS-232C settings are correct. If they are incorrect, correct them and then reset the POWER switch.
What to do if START switch does not work on Kikusui Test Equipment?
If the START switch isn't working, check the following: * Is the STOP signal input? * Is the tester in PROTECTION, PASS, or FAIL status? * Are you currently making settings for the system and interface or editing a program? * Are you currently storing data in or recalling it from the panel memory? * Is the double-action function valid? * Is “READY” displayed? * Is the ENABLE signal for SIGNAL I/O at the low level?
What to do if a panel key does not work on Kikusui TOS9200 Test Equipment?
If a panel key isn't working, consider these potential causes: * Is the Key Lock function working? * Is the panel key remotely controlled from the REMOTE terminal or SIGNAL I/O? * Is the panel key remotely controlled from outside via the GPIB or RS-232C?
What to do if Kikusui TOS9200 Test Equipment does not start when the POWER is turned on?
If the tester does not start when the POWER is turned on, check if the power cord is disconnected or if the fuse is broken.
What to do if the LCD screen does not appear when the POWER is turned on Kikusui TOS9200 Test Equipment?
If the LCD screen does not appear when you turn on the power, it might be because the contrast level is too low, or the ambient temperature is too low.
What to do if the output voltage does not reach 2.6 kV on Kikusui TOS9200 Test Equipment?
If the output voltage does not reach 2.6 kV, check if the output voltage range is set to AUTO.
General| Category | Test Equipment |
|---|---|
| Type | Withstanding Voltage Tester |
| Output Capacity | 500 VA |
| Ramp Time | 0.1 to 999.9 s |
| Output Current Range | AC: 0 to 100 mA, DC: 0 to 10 mA |
| Frequency | 50 Hz / 60 Hz |
To Next Page
