Kilotech KPC 2000-03A - Auto-Off Function; Low Battery Signal; Zero;On;Off; Tare;Unit

KPC 2000, Operaons Manual E 12202017, Page 4 of 5
ZERO/ON/OFF:
• When the scale is o, press the ZERO /ON/OFF key to turn the scale ON. The scale will enter
self-examinaon. The working voltage “x.x Udc” will be displayed. The full capacity will be displayed as
“F3.000kg”, “F6.000kg” or “F15.000kg”.
• When the scale is on, press the ZERO /ON/OFF key for less than 5 seconds. The ZERO key funcon will acvate.
• The Zero key can only be acvated within 5% of the scale’s capacity.
• The scale should be stable and the plaer empty.
• Press the ZERO /ON/OFF key for more than 5 seconds to acvate the ON/OFF funcon
TARE /UNIT:
• Press this buon for less than 5 seconds, the TARE key funcon will acvate. Press this buon for more than
5 seconds, UNIT key funcon will acvate:
• TARE: TARE range for this scale is up to 102%FS. This funcon should be operated when the scale is in stable
mode. When the TARE funcon is acve, the “NET” LED will be on. [Note: (Gross weight = Net weight + Tare
weight ≤102% FS)
• UNIT: To change the weight unit, hold the TARE/UNIT buon for more than 5 seconds or unl your desired
weight unit appears.
CALIBRATION:
• See Calibraon video or Calibraon Manual
AUTO-OFF FUNCTION:
• When the scale is on, simultaneously press and hold down the TARE and ZERO buons for more than
5 seconds ll the “A.oFF.x” is displayed. X = 0,1…9:
• The AUTO-OFF FUNCTION is used to save baery power.
• You can set the amount of me from 0-9 minutes. If you set to 2 minutes, the scale will shut o aer
2 minutes in idle mode.
• When X = 0, the auto-power o funcon is disabled.
• Press the TARE buon to choose the auto-o me and press ZERO buon to conrm and save the seng.
LOW BATTERY SIGNAL:
The scale may be powered by the rechargeable baery or 110 AC CUL US approved adapter. When “Lo.bAt” is dis-
played alternavely, this indicates that the baery is low and will require a charging. The voltage of internal work-
ing is below 5.7V(+0.1V)