Do you have a question about the Kind XT and is the answer not in the manual?
Activates limiter function to protect loudspeakers from high power or distorted signals.
Disconnects loudspeakers and shuts down if heatsink temperature becomes too high.
Automatically protects amplifier from output shorts or loads below 1 Ohm.
Opens output relay immediately if DC voltage is detected at the output terminals.
| power output per channel RMS 8Ω | 400W |
|---|---|
| 1KHz (1% THD) both channels driven 4Ω | 650W |
| 1KHz (1% THD) both channels driven 2Ω | 900W |
| bridge MONO 8Ω | 1300W |
| bridge MONO 4Ω | 1800W |
| distortion (THD) | <0.05 |
|---|---|
| frequency response | 10 Hz to 30 KHz +0, -1.0dB |
| input sensitivity (unbalanced) | +4dB (1.2V) |
| input impedance | 20 KΩ Balanced |
| signal-to-noise ratio | Greater than -96dB ref. full output power, 20Hz to 20 KHz |
| slew rate | 25VµS |
| damping factor 8Ω 10Hz to 1KHz | >400 |
| dimension WxHxD / U rack 19" | 483x133x453 / 3U |
|---|---|
| weight net | 23 kg |
| weight packed | 26 kg |
| power output per channel RMS 8Ω | 600W |
|---|---|
| 1KHz (1% THD) both channels driven 4Ω | 900W |
| 1KHz (1% THD) both channels driven 2Ω | 1300W |
| bridge MONO 8Ω | 1800W |
| bridge MONO 4Ω | 2600W |
| distortion (THD) | <0.05 |
|---|---|
| frequency response | 10 Hz to 30 KHz +0, -1.0dB |
| input sensitivity (unbalanced) | +4dB (1.2V) |
| input impedance | 20 KΩ Balanced |
| signal-to-noise ratio | Greater than -96dB ref. full output power, 20Hz to 20 KHz |
| slew rate | 25VµS |
| damping factor 8Ω 10Hz to 1KHz | >400 |
| dimension WxHxD / U rack 19" | 483x133x453 / 3U |
|---|---|
| weight net | 26 kg |
| weight packed | 29 kg |
| power output per channel RMS 8Ω | 790W |
|---|---|
| 1KHz (1% THD) both channels driven 4Ω | 1250W |
| 1KHz (1% THD) both channels driven 2Ω | 1600W |
| bridge MONO 8Ω | 2500W |
| bridge MONO 4Ω | 3200W |
| distortion (THD) | <0.05 |
|---|---|
| frequency response | 10 Hz to 30 KHz +0, -1.0dB |
| input sensitivity (unbalanced) | +4dB (1.2V) |
| input impedance | 20 KΩ Balanced |
| signal-to-noise ratio | Greater than -96dB ref. full output power, 20Hz to 20 KHz |
| slew rate | 25VµS |
| damping factor 8Ω 10Hz to 1KHz | >400 |
| dimension WxHxD / U rack 19" | 483x133x453 / 3U |
|---|---|
| weight net | 28 kg |
| weight packed | 31 kg |
| power output per channel RMS 8Ω | 1200W |
|---|---|
| 1KHz (1% THD) both channels driven 4Ω | 1800W |
| 1KHz (1% THD) both channels driven 2Ω | 2400W |
| bridge MONO 8Ω | 3600W |
| bridge MONO 4Ω | 4800W |
| distortion (THD) | <0.05 |
|---|---|
| frequency response | 10 Hz to 30 KHz +0, -1.0dB |
| input sensitivity (unbalanced) | +4dB (1.2V) |
| input impedance | 20 KΩ Balanced |
| signal-to-noise ratio | Greater than -96dB ref. full output power, 20Hz to 20 KHz |
| slew rate | 25VµS |
| damping factor 8Ω 10Hz to 1KHz | >400 |
| dimension WxHxD / U rack 19" | 483x133x453 / 3U |
|---|---|
| weight net | 31 kg |
| weight packed | 34 kg |
Loading...