FITTING THE TRIM
a) Remove the protective tape from the trim and position onto the fixing
flange. The trim is secured with magnets.
USER REPLACEABLE PARTS
The only user replaceable parts on this fire are the fuelbed components and coals
which may be replaced as described in the above section. Replacement of any
other parts must be carried out by a competent person such as a CORGI
registered gas installer.
The part numbers of the user replaceable parts are as follows, these are available
from specialist spares stockists whose details can be found on our web site,
www.bfm-europe.com, in the ‘stockist’ section.
Complete coal ceramic set (base front rails and coals) B-96430
Coal fuelbed base B-96400
Coal fuelbed front rails (pair) B-96410
Replacement coal set B-96420
Complete pebble ceramic set (base, front rails and pebbles) B-107340
Pebble fuelbed base B-107350
Pebble fuelbed front rail L/H B-107360
Pebble fuelbed front rail R/H B-107370
Replacement pebble set B-107380
To enable Customers to choose their own style of fret these fires are now available
without frets.
In order to maintain the efficient and safe operation of the fire it is important that
any fret which is used must comply with the following dimensions.
It is important to clean a fret in accordance with the instructions provided by your
retailer as these vary depending on the surface finish of the fret. Fig. 15
17
Maximum
Height
210mm
Two Air Slots Each of Minimum
Area 19cm2
Minimum total
open area of
Fret 110cm2
Fig. 15
To Next Page
Loading...
