To Next PageTo Next Page
Need help?Do you have a question about the Kinder Rocco MK2 and is the answer not in the manual?
Details about the appliance's specifications, including injector type, pilot type, heat input, gas rate, and pressure.
Legal and regulatory requirements for installing the gas appliance, referencing relevant standards and regulations.
Minimum dimensions and suitability requirements for conventional brick or lined chimneys and fabricated flues.
Guidelines for the safe placement of combustible shelves above the appliance, specifying minimum distances.
Requirements for the non-combustible base for the appliance, specifying a minimum thickness.
Specific instructions for preparing plastered walls, including material removal and replacement for sealing.
Steps for safely unpacking the main firebox and checking all listed contents before proceeding.
Instructions for creating an opening in a studded wall, detailing required clearances for the flue liner and mounting frame.
Instructions for creating an opening in an existing chimney breast, specifying dimensions and lintel requirements.
Steps for attaching the mounting frame to secure the combustion chamber, including details on securing screws.
Procedures for connecting the gas supply pipework to the appliance, including options for left, right, or rear entry.
Guidance on how to safely remove and refit the glass frame, ensuring a consistent seal is achieved.
Instructions for connecting a flexible flue liner to the 5" / 125mm spigot adaptor, securing with retaining clips.
Steps for fitting the flue terminal and re-fitting the draught diverter, ensuring correct orientation.
Detailed steps for arranging the ceramic logs on the fuel bed, ensuring correct placement and orientation.
Procedures for connecting gas supply pipework and performing a gas tightness test before operation.
Instructions for safely igniting the pilot and main burner, including manual and remote control operation.
Steps for removing and re-attaching the appliance's decorative aluminium trim, noting magnetic retention.
How to perform a smoke test to ensure proper ventilation and clearance of combustion products from the room.
Step-by-step guide to safely removing the burner assembly for servicing, including isolation of gas supply.
Procedure for safely removing and replacing the control valve, ensuring gas isolation and tightness checks.
Instructions for safely disconnecting and removing the ultrasonic receiver component from its mounting cradle.
Steps to safely remove the pilot assembly, including disconnection of pilot pipe and ignition lead.
Guidance on replacing the AA batteries in the ultrasonic receiver unit.
Instructions for replacing the 9V battery in the remote control handset.
A list of available spare parts for the appliance, including part numbers and model codes.
General| Power Source | Electric |
|---|---|
| Voltage | 220-240V |
| Thermostat | Adjustable |
| Safety Features | Overheat protection, Tip-over switch |
| Frequency | 50Hz |
