Why is my King gates Garage Door Opener not responding to the remote, even though the LED is on?
If your King gates Garage Door Opener transmitter's LED lights up but doesn't control the door, ensure the transmitter is correctly memorized in the radio receiver. To test the radio signal, press a key and place the LED on the transmitter near the antenna of a radio tuned to 108.5MHz FM. A slight crackling sound should be audible.
What to do if my King gates Garage Door Opener starts moving, but then immediately goes back?
If your King gates Garage Door Opener starts a maneuver but immediately reverses, the selected force might be too low for the door type. Check for any obstructions and increase the force if necessary.
How to fix a King gates OVO550 that won't start and the OK LED is not flashing?
If your King gates Garage Door Opener isn't starting and the OK LED isn't flashing, verify that the OVO is receiving 230V mains power. Also, inspect fuses F1 and F2 (fig. 46); if they're blown, determine the cause before replacing them with fuses of the same rating and specifications.
What to do if my King gates OVO550 Garage Door Opener doesn't start and the flashing light is off?
If your King gates Garage Door Opener is not starting and the flashing light is off, ensure that the command is being received. When a command reaches the Step-by-Step input, the OK LED will flash twice, indicating receipt of the command.
Why is the STOP LED off on my King gates OVO550?
If the King gates Garage Door Opener's STOP LED is off, it indicates activation of the STOP input. Check the devices connected to the STOP input.
How to fix King gates OVO550 Garage Door Opener when the remote doesn't work and the LED is off?
If your King gates Garage Door Opener isn't responding to the remote and the LED on the transmitter isn't lighting up, the transmitter batteries may be dead. Replace them to resolve the issue.
What does it mean when my King gates OVO550 Garage Door Opener flashing light blinks a few times and it won't start?
If your King gates Garage Door Opener is not starting and the flashing light flashes a few times, count the flashes and consult table 14 to identify the issue.
What does '2 flashes 1 second pause 2 flashes' mean on my King gates OVO550?
If your King gates Garage Door Opener flashes 2 times, pauses for a second, and then flashes 2 times again, it indicates that one or more photocells are being triggered, preventing movement. Check for obstructions. This is normal if something is blocking the closing movement.
What does '4 flashes 1 second pause 4 flashes' mean on my King gates OVO550?
If your King gates Garage Door Opener flashes 4 times, pauses for one second, and then flashes 4 times again, it means the STOP input was activated at the start of or during the maneuver. Identify the cause of the STOP input activation.
What does '3 flashes 1 second pause 3 flashes' mean on my King gates OVO550 Garage Door Opener?
If your King gates Garage Door Opener flashes 3 times, pauses for a second, and flashes 3 times again, it indicates the activation of the motor force limiting device. This means the door experienced excessive friction during movement; identify what is causing the friction.
General| Protection Level | IP44 |
|---|---|
| Warranty | 2 years |
| Motor Voltage | 230V |
| Max Door Weight | 100kg |
| Lifting Capacity | 100kg |
| Safety Features | Obstacle detection |
| Motor Type | Electromechanical |
To Next Page