Why my King Industrial Saw will not start?
If your King Industrial Saw won't start, there are several potential causes. First, ensure the saw is properly plugged in. If it is, check the fuse or circuit breaker and replace or reset it if necessary. A damaged cord could also be the culprit, in which case you should have it replaced by a certified electrician. Lastly, the overload relay might not be set; try pushing the overload reset button.
Why does the overload keep kicking out on my King Industrial Saw?
If the overload on your King Industrial Saw is kicking out frequently, it could be due to several reasons. Using an extension cord that is too light or too long can cause this issue, so try replacing it with an adequate size cord. Feeding the stock too fast can also overload the saw; try feeding the stock more slowly. A blade in poor condition (dull, warped, or gummed) can cause the overload to kick out, so clean or replace the blade. Additionally, a misaligned rip fence or warped wood can cause the blade to bind, so check and adjust the rip fence or select another piece of wood. Finally, low house current can also cause this issue, so contact your electrical company.
General| Motor Power | 15 Amp. |
|---|---|
| Weight | 35 lbs |
| Voltage | 120V |
| Blade Diameter | 10 inch |
| Arbor Size | 5/8 inch |
| Maximum Cutting Depth at 90 Degrees | 3" |
| Maximum Cutting Depth at 45 Degrees | 2" |
| No Load Speed | 5000 RPM |
| Max Cutting Depth at 45° | 2" |
To Next Page
