12
Turn off pump. Turn dial to 0.
This reduces the ow of water
into the unit when the cap is
open.
Pack
Tower
Pack
Tower
Open the cap. Stand back to
allow any chlorine fumes to
dissipate.
Key in
Cycler
Opening
in Pack
MIN.
MAX
Model 120
Model 400
1.
The Prevail Pool Packs are
made of HDPE plastic. Non-
rellable container. Do not
reuse or rell this container.
Offer for recycling if available.
Rinse thoroughly before
recycling or discarding in trash.
Mark calendar ahead for the
approximate replacement times
for the Prevail Pool Pack.
2.
7.
8.
3.
Cut handle from Prevail Pool Pac using a PVC cutting tool
(KEEP OUT OF REACH OF CHILDREN)
3A. Find
the indent in
the plastic.
3B. Place curved section of
tool around the narrow end
of one pack tower and line up
blade on indent
3E. If openings are pinched
together, open with ngers or
re-cut closer to the colored
screens inside Prevail Pool
Pack. Leave at least 1/4” of
plastic to t into Prevail Cycler
base.
4.
Invert Prevail Pool Pack and
shake slightly until chlorine
tablets fall into tower areas.
Insert Prevail Pool Pack into
Prevail Cycler, lining up the
openings in Prevail Pool Pack
with keys in Prevail Cycler.
NOTE: Openings are a different
shape than keys.
Replace cap by hand only.
DO NOT OVERTIGHTEN.
5.
6.
PVC cutting tool
available at local
hardware stores.
Step 2: Putting the System to Work
A correct
oval
opening
Avoid a
pinched
opening.
WARNING
Avoid sparks, smoking, or any open ame near
Prevail Cycler or chemicals.
DANGER
Never use fast dissolving chlorine tablets, liquid bleach,
or calcium hypochlorite in the Prevail Cycler.
IMPORTANT: Read the label on the Prevail Pool Pack carefully
before using.
3C.. Squeeze the handles
together. Repeat for other side.
3D.. Make sure the blade
comes straight across on the
indent line for a clean cut.
Finished cut ends
WE RECYCLE
To Next Page
Loading...
Need help?
General
